ACCESSORIES for COAXIAL TRIAXIAL

QUADAXIAL

NEEDLES

 

PTFETUBINGKIT

 

The PTFE Tubing Kit includes (1) two-foot length of ramé-hart PTFE Tubing (p/n 100-10-PTFE-2), (1) Male Luer Coupling for PTFE Tubing (p/n 100-10-PTFE-M) and (1) Female Luer Coupling for PTFE Tubing (p/n 100-10-PTFE-F). This kit will connect one needle to one syringe. The tubing is rated for 300 psi and up to 265°C. The tubing inside diameter is 1.5mm (0.06 inch). 

Order the kit or any of the components of the kit here

LUERCOUPLINGS

 

ramé-hart offers Luer Lock Couplings to interface with tubing

Use the Male Luer Lock Coupling (right above) to connect the Luer Lock inlet on any ramé-hart needle product to tubing via the barbed fitting. Order here

Use the Female Luer Lock Coupling (right below) to connect any syringe with a male Luer connection to tubing. Order here

These fittings support chemical-resistant Tygon Tubing. Order here.

ELECTROSPINNINGCHECKTOOL

 

The Electrospinning Check Tool p/n 100-70-01 is used to check the validity of your electrospinning process. This stainless steel tool enables the user to verify if fiber is being produced by running the spray across the openings. If fiber is being produced, then the fiber will be visible over the hole; otherwise, the electrospinning spray will fall through the holes. This is a quick and easy way to verify in less than a minute whether or not your electrospinning device is producing fibers properly and can be done without using a microscope. 

Order the Electrospinning Check Tool here

PTFEWASHERS

All current-generation ramé-hart coaxial, triaxial, and quadaxial needles can be separated by component. A custom-made solid PTFE Washer is used to seal the juncture between components. Over time, these washers can become compressed and wear out. Order p/n 100-10-COAX-WASHER for a pack of (3) PTFE Washers here

PTFEWASHERS

All current-generation ramé-hart coaxial, triaxial, and quadaxial needles can be separated by component. A custom-made solid PTFE Washer is used to seal the juncture between components. Over time, these washers can become compressed and wear out. Order p/n 100-10-COAX-WASHER for a pack of (3) PTFE Washers here

DISASSEMBLYWRENCH

Use the Disassembly Wrench p/n 100-70-02 to take apart any ramé-hart prebuilt or custom coaxial, triaxial, or quadaxial needle for cleaning. The wrench can also be used to re-assemble the needle. For disassembly instructions see this image. Order the Disassembly Wrench here

©2011-2019 ramé-hart instrument co. 
For Goniometers and Tensiometers, please visit www.ramehart.com

To order coaxial and triaxial spinneret and related products, please visit www.ramehart.us

  • w-facebook
  • Twitter Clean
  • Flickr - White Circle
  • White LinkedIn Icon